OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U017C

Lost Communication With Restraints System Sensor M

U017C is stored once restraint sensor M, the thirteenth remote crash sensor, falls silent. No manufacturer documents U017C publicly. For diagnosis it matters whether the code is current or only stored: according to the PSI5 working group, a brief drop in supply makes a sensor restart and send initialisation data first, so a loose contact can leave a history entry without a lasting fault. Wiggle tests on the connector and harness while watching live status are therefore more useful than replacing parts. Mechanical fit counts too: Audi, for example, inserts its capacitive door pressure sensors into the inner door panel with a seal and turns them to lock, and a poorly seated sensor after trim work can fail. U047D reports invalid data instead of silence. No MIL.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number1 / 7C

Possible causes

  • Intermittent contact at sensor M connector (history code) high
  • Sensor not seated or sealed correctly after trim work medium
  • Sensor wiring chafed or open medium
  • Crash sensor M failed low

Symptoms

  • Airbag warning lamp on or flickering
  • Code stored as history after the lamp went out again
  • Impact detection in the zone of sensor M unavailable while active

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for U017C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication