U0179
Lost Communication With Restraints System Sensor J
U0179 closes the J2012 block for remote restraint sensors and names sensor J, the tenth position (the letter I is used as well, see U0178). The airbag control unit checks that each connected satellite keeps sending; if sensor J falls silent, the unit stores U0179, switches on the airbag warning lamp and may disable the deployment paths that rely on it. No manufacturer documents U0179 publicly, and Chrysler's published Jeep list stops at the sixth satellite (U0176), so this code is rare. Bosch describes peripheral sensors in front, side and rear positions, which explains why up to ten slots exist. U0170 to U0178 cover sensors A to I, U0151 the airbag unit itself. No MIL; repairs only by trained staff.
Possible causes
- Connector at sensor J loose or corroded high
- Open or shorted line between sensor J and the airbag unit medium
- Crash sensor J failed, e.g. after a minor impact medium
- Airbag control unit input faulty low
Symptoms
- Airbag warning lamp on
- Restraint deployment relying on sensor J may be disabled
- Scan tool shows sensor J as not responding
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U0179
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.