U0178
Lost Communication With Restraints System Sensor I
U0178 covers restraint sensor I, the ninth remote crash sensor; unlike many letter series, J2012 does use the letter I here. No manufacturer documents U0178 publicly. High sensor counts come mainly from combining sensor types: Bosch connects two or four door pressure sensors to the airbag unit in addition to the acceleration sensors on the body structure, so a four-door car can easily exceed eight satellites. A pressure sensor in the door cavity registers the pressure rise when the door is pushed in. Its wiring passes through the door hinge area, where repeated opening can break conductors, and water inside the door can reach the connector. Such sensors are often linked via PSI5, a two-wire interface. U0479 reports invalid data from the same sensor. No MIL.
Possible causes
- Broken wire in the door hinge passage high
- Water inside the door at the sensor connector (failed vapour barrier) medium
- Sensor I failed medium
- Sensor interface of the airbag unit faulty low
Symptoms
- Airbag warning lamp on
- Fault may come and go with door movement
- Impact detection in the zone of sensor I unavailable
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U0178
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.