U0177
Lost Communication With Restraints System Sensor H
U0177 is stored when crash sensor H, the eighth remote sensor of the restraint system in J2012 lettering, stops reporting to the airbag control unit. Remote acceleration or pressure sensors detect front, side or rear impacts early and feed the central unit that decides on deployment. No manufacturer documents U0177 publicly. Chrysler's Jeep airbag list from 2006-2010 shows how the block is used, assigning U0170 to U0176 to front and side satellites, but ends before H; so U0177 only appears on vehicles with very many satellites. Siblings U0170 to U0176, U0178 and U0179 name the other sensor positions. Result: airbag warning lamp on, possibly reduced protection in one zone, no MIL. Leave airbag work to a workshop.
Possible causes
- Connector at sensor H loose, wet or corroded high
- Sensor wiring damaged by trim or body work medium
- Crash sensor H failed medium
- Airbag control unit input faulty or wrong configuration low
Symptoms
- Airbag warning lamp on
- Impact detection in the zone of sensor H unavailable
- Code returns immediately after clearing
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U0177
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.