U0174
Lost Communication With Restraints System Sensor E
U0174 refers to restraint sensor E, the fifth remote crash sensor in J2012 lettering. No manufacturer documents U0174 publicly. Chrysler's Jeep tables in NHTSA file PE11-019 go from U0173 straight to U0175, so slot E is simply not used there. Where it is fitted, such a sensor usually hangs on a two-wire PSI5 line that carries power and data at once: the control unit sends sync pulses and expects the reply in a fixed time slot, so an open wire, a short or a dead sensor shows up as missing frames. Before buying parts, check with a scan tool whether the airbag unit is really configured for sensor E; a replacement unit with the wrong coding can complain about sensors the car does not have. U0475 is the invalid-data partner. Airbag lamp on, no MIL.
Possible causes
- Airbag unit coded for a sensor E that is not fitted (e.g. after unit replacement) medium
- Connector at sensor E loose, wet or corroded high
- Two-wire sensor line open or shorted medium
- Crash sensor E internally failed low
Symptoms
- Airbag warning lamp on
- Scan tool lists sensor E as not responding
- Deployment paths depending on sensor E may be blocked
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U0174
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.