U015E
Lost Communication With Automated Driving System Interface Module A
U015E concerns interface module A, the link that passes commands from an automated driving computer to the base vehicle's brakes, steering and powertrain and reports their state back. Such interfaces belong to the act layer of the sense-think-act chain that Bosch uses to describe automated driving. When its messages stop, the automation computer can no longer command the actuators, so it has to hand control back to the driver or reach a safe stop. No manufacturer documents U015E publicly, and SAE J3016 defines only the automation levels, not the hardware. U015F is interface module B, U015C and U015D are the control modules, U045F flags implausible data from A.
Possible causes
- Interface module A without power or ground high
- Bus or Ethernet connection to the interface damaged or strained medium
- Interface and automation computer on mismatched software medium
- Interface module A internally faulty low
Symptoms
- Automated driving mode cannot be activated
- Takeover request or controlled stop during automated driving
- Driver assistance warning in the cluster
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U015E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.