U0152
Lost Communication with Side Restraints Control Module Left
A control module that expects to talk to the engine ECU has stopped receiving messages. Most commonly seen by the TCM, instrument cluster, or BCM after the ECU has been disconnected, fitted with a faulty replacement, or the CAN wiring has been damaged. Engine usually will not run while this fault is active in other modules.
Possible causes
- Side SRS module unpowered high
- CAN wiring to side SRS broken medium
- Gateway module routing CAN messages incorrectly low
Symptoms
- Multiple warning lights may illuminate
- Affected modules may go into limp mode or shut down
- Specific functions inoperative depending on module
- Diagnostic tools may show communication faults
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
- Estimated cost: 150–1800 €
- Estimated time: 1–4 h
- Component: side restraints module left
- Component: can bus wiring
- MIL / check engine light