U0150
Lost Communication With Gateway E
U0150 is the last code of the gateway block and points at Gateway E. Gateways are central nodes that connect bus systems of different speed and type and forward only the messages each side needs. When E stops sending, the modules that expect its traffic log U0150, the way GM's U0100-U02FF procedure describes for any silent sender: a supervised periodic message is missing although supply voltage is in range. No manufacturer documents U0150 publicly; GM's U-code list ends its gateway entries at U0146. U0146 to U0149 refer to gateways A to D. Before suspecting the gateway, check power, ground and the bus lines to it; a code stored only in history after battery work needs no repair. MIL normally stays off.
Possible causes
- Gateway E fuse blown or ground loose high
- Bus line to gateway E chafed or connector corroded medium
- Gateway E software fault, update or reprogramming needed low
- Gateway E internally faulty low
Symptoms
- Modules routed through gateway E not reachable by the scan tool
- Several functions fail together
- Warning messages in the instrument cluster
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U0150
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- saabwisonline.com/9-5-9650/2011/3-electrical-system/bus-and-diagnostics-communication/fault-diagnosis-diagnostic-trouble-codes/dtc-u0100-u02ff
- bosch-mobility.com/en/solutions/vehicle-computer/central-gateway/
- saabwisonline.com/9-5-9650/2011/3-electrical-system/bus-and-diagnostics-communication/fault-diagnosis-diagnostic-trouble-codes/control-module-u-code-list