U014B
Lost Communication With Hybrid/EV Battery Inductive Charging Module
U014B covers the vehicle-side controller of a wireless charging system. Inductive charging transfers energy without a plug, through a coil in a ground pad and a receiving coil under the car; the SAE J2954 standard, finalised in 2020, defines power classes of 3.7, 7.7 and 11 kW and relies on resonant coupling with about 85 percent efficiency. The module on board rectifies the received power, checks alignment and reports to the battery and charge controllers; if its messages stop, those controllers log U014B. No manufacturer documents the code publicly, and wireless charging is still rare in series production. The practical effect is that wireless charging does not start or is interrupted, while charging by cable and driving normally continue. U044C covers invalid data from this module.
Possible causes
- Supply, fuse or ground of the inductive charging module missing high
- Wiring or connector to the underbody receiver damaged by water, salt or impact medium
- Software of module and charge controller not matching low
- Inductive charging module internally faulty low
Symptoms
- Wireless charging does not start or stops
- Charging warning message, cable charging still works
- Module not reachable with a scan tool
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U014B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.