Network
generic / SAE
U0148
Lost Communication with Body Control Module "C"
The Body Control Module "C" has stopped transmitting on the vehicle data bus, so other control units no longer receive its messages. A third body controller is unreachable; its assigned body functions are affected. Typical causes are loss of power or ground at the module, an open or shorted CAN/LIN bus wire, a connector fault, or an internal module failure.
SystemNetwork
Typegeneric / SAE
GroupU0
Range / number1 / 48
Possible causes
- BCM-C unpowered high
- CAN wiring to BCM-C broken medium
- Gateway module routing CAN messages incorrectly low
Symptoms
- Multiple warning lights may illuminate
- Affected modules may go into limp mode or shut down
- Specific functions inoperative depending on module
- Diagnostic tools may show communication faults
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
- Estimated cost: 100–1800 €
- Estimated time: 1–6 h
- Component: body control module
- Component: can bus wiring
- MIL / check engine light
Sources
References
sae:J2012