U013C
Lost Communication With Accelerator Pedal Module
U013C applies to an accelerator pedal module that reports over a data bus instead of analog sensor lines. In a drive-by-wire system the pedal module carries the driver's torque request to the engine or drive controller, so that controller has to fall back to a safe state as soon as the pedal messages disappear. No manufacturer documents U013C publicly; most pedals still use two analog tracks, whose faults appear as circuit codes such as P2122 or P2127 instead. CARB requires lack of communication from a digital input to be detected separately and stored as its own fault code. U043D covers implausible pedal data. Expect reduced power or idle only, a warning lamp and, depending on the manufacturer, the MIL.
Possible causes
- Loose or corroded connector at the pedal module (footwell moisture) high
- Supply, ground or bus wiring of the pedal module faulty medium
- Accelerator pedal module internally faulty low
Symptoms
- No response to the accelerator, engine stays at idle
- Reduced power warning
- MIL on depending on the manufacturer
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for U013C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.