OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0136

Lost Communication With Differential Control Module - Rear

U0136 is set when a listener misses the rear differential control module, which operates an electronic limited-slip or twin-clutch rear drive unit. GM's 2019 tables document it in the ECM of the Cadillac XT4 (LSY engine): if message $1CF from the rear drive module stays absent for 10 s while bus A is active and supply exceeds 11 V, the ECM stores U0136 as a Type B fault, so the MIL comes on after two trips. Saab's 2011 9-5 list (XWD all-wheel drive) also names the rear differential module and adds byte 71 for invalid data. Implausible rear-differential data has its own code U0437; the front axle uses U0135. Rear torque distribution switches off with a warning, and the car usually continues with front-wheel drive.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number1 / 36

Possible causes

  • Fuse, supply, ground or CAN wiring of the rear drive module faulty high
  • Corroded or damaged connector at the rear axle, exposed to spray water medium
  • Rear differential control module internally faulty low

Symptoms

  • AWD or rear differential warning
  • Car drives with front-wheel drive only, less traction
  • MIL after two trips on GM vehicles

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U0136

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication