U011D
Lost Communication With All Wheel Drive Control Module
U011D signals a lost all-wheel-drive control module. In contrast to a single coupling controller (U0114) or a transfer case module (U0102), this unit manages an entire on-demand AWD system, deciding when and how much torque goes to the secondary axle, which in some cars is driven by its own electric motor. It draws wheel speed, steering and torque data from the bus and reports its state to stability control. No manufacturer documents U011D publicly; Stellantis, for one, files the case under U0102, which its Jeep Wrangler bulletin 23-033-25 calls Transfer Case Control Module/AWD. Typical consequences are an AWD warning lamp and drive on one axle only; emissions are not affected, so a MIL is not expected.
Possible causes
- AWD module without power or ground high
- Water or corrosion at the module connector near the rear axle medium
- Chafed or open CAN wiring to the module medium
- All-wheel-drive control module internally faulty low
Symptoms
- AWD warning lamp or message
- Drive on one axle only
- Stability control may also show a warning
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for U011D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.