U0118
Lost Communication With Fuel Additive Control Module
U0118 concerns the fuel additive control module, which on some diesel cars meters a fuel-borne catalyst from a separate tank into the fuel. The additive lowers the temperature at which trapped soot burns in the particulate filter from above 600 °C to roughly 350–450 °C. If the engine controller no longer receives this module, it cannot be sure that dosing continues, and the regeneration strategy loses its footing. No manufacturer documents U0118 publicly; the text rests on CARB's requirement for a separate lack-of-communication code and on the known function of fuel-borne catalysts. Neighbours are U0467 (invalid data), P2584 (MIL request) and P2585 (warning lamp request) from the same module. Left unrepaired, the filter tends to clog, bringing a DPF warning and reduced power.
Possible causes
- Additive module unplugged or its fuse removed, e.g. after filter work high
- Corroded connector at the additive tank or module under the vehicle medium
- Damaged CAN wiring to the additive module medium
- Fuel additive control module internally faulty or not coded low
Symptoms
- MIL and particulate filter warning
- Regeneration fails, filter loads up
- Reduced power in later stages
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for U0118
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.