U0114
Lost Communication With Four-Wheel Drive Clutch Control Module
U0114 says the controller of a four-wheel-drive clutch has gone quiet. Such a unit sets how much torque reaches the secondary axle by clamping a multi-plate coupling, as in Haldex-type on-demand drivelines whose later generations carry their own integrated electronics. It needs wheel speeds, engine torque and brake status from the bus and is usually missed by the engine, transmission or ABS controller. Ford's 2014 powertrain code interpretation lists U0114, but no maker publishes timing or lamp logic for it. A transfer case controller has U0102, a complete all-wheel-drive module U011D, invalid clutch data U0414. In practice the car drives on one axle with an AWD warning; engine running and emissions stay unaffected.
Possible causes
- Clutch module without power or ground (fuse, connector near the rear axle) high
- Water or corrosion in the module connector exposed under the car medium
- Chafed or open CAN lines to the rear of the vehicle medium
- Clutch control module internally faulty low
Symptoms
- AWD/4WD warning in the cluster
- Drive only on the primary axle, wheelspin on slippery roads
- Possibly stability control warning
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for U0114
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.