U0112
Lost Communication With Battery Energy Control Module B
U0112 is logged when a second battery energy control module, B, stops talking on the bus while a partner still waits for its data. Mitsubishi's 2018 Outlander PHEV is a documented case: the main battery management unit (BMU) supervises a sub-BMU inside the traction pack and stores U0112 once that unit's frames have been missing for 0.3 s, after the BMU has seen 8–16 V for more than 2 s; the check follows drive-cycle pattern 1, and the CAN pair between the two units should measure 100–140 Ω. VW's 2014 Touareg Hybrid lists the code for absent BECM messages, and GM's Saab 9-4X list assigns it to its battery module. Module A has U0111. Typical results are a hybrid warning, less electric range or no READY.
Possible causes
- Open, shorted or chafed CAN lines between main and sub battery module inside the pack high
- Corroded or loose connector at the traction battery medium
- Battery module B internally faulty or without supply medium
- Receiving main battery module faulty low
Symptoms
- MIL or hybrid system warning
- Reduced electric range or electric drive unavailable
- Vehicle does not reach READY
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U0112
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- mitsubishitechinfo.com/data/REEV/2018/54/HTML/M154941040001600USA.htm
- static.nhtsa.gov/odi/tsbs/2014/MC-10074008-2280.pdf
- saabwisonline.com/9-4x/2011/3-electrical-system/bus-and-diagnostics-communication/fault-diagnosis-diagnostic-trouble-codes/control-module-u-code-list
- law.cornell.edu/regulations/california/13-CCR-1968.2