OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0111

Lost Communication With Battery Energy Control Module A

U0111 indicates that battery energy control module A, which measures cell voltages, temperatures and current of the high-voltage or 48 V battery, has dropped off the network. GM's 2018 Volt hybrid controller expects it on bus A and sets the code as Type B over two trips once messages have been absent for 5 s above 10.2 V; while it is pending, GM suspends pack voltage and current plausibility checks. GM PIC5829 (Volt 2011–2013) advises updating the BECM calibration instead of replacing it. In the Jeep Wrangler 4xe the battery module may fail to wake in severe cold, so the hybrid controller logs U0111-00 (case S2108000056). Land Rover reports 48 V MHEV BECMs going offline with MIL and lost start-stop. U0112 is module B.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number1 / 11

Possible causes

  • Battery module software or calibration fault (update released) high
  • Module fails to wake up in extreme cold or after a 12 V dip medium
  • Damaged CAN lines or connector at the battery pack medium
  • Battery energy control module internally faulty low

Symptoms

  • MIL or service-hybrid/charging warning
  • No READY, electric drive or charging unavailable
  • Start-stop inoperative (mild hybrid)
  • 12 V battery drained

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for U0111

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication