OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0110

Lost Communication With Drive Motor Control Module A

U0110 means drive motor control module A, the power electronics running the electric traction motor of a hybrid or EV, has stopped talking. Audi's TSB 2065538/1 (Q5 and A7 PHEV, 2019–2021) finds U011000 in the transmission controller after a brief 12 V dip trips the low-voltage monitor; a full bus sleep of about 20 minutes plus clearing codes cures it. Mazda bulletin 09-027-26 (CX-70/CX-90 PHEV) sees U0110 with U0100, U0115 and P0AB9 when water corrodes connector 3002-411 and READY fails in the cold. GM's 2025 gateway table sets it as Type B over two trips once a monitored frame lags 2.5 times its cycle across 6.5 s. Toyota flagged it on the 2017–2019 Highlander Hybrid. Expect no READY, red warnings or limp mode.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number1 / 10

Possible causes

  • 12 V battery weak or voltage dip, inverter electronics drop off the bus high
  • Water or corrosion in high- or low-voltage connectors of the drive system medium
  • Damaged CAN lines to the inverter medium
  • Drive motor control module internally faulty low

Symptoms

  • Vehicle does not enter READY or will not start
  • Red drive-system or electrical warning
  • Electric drive unavailable, limp mode

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for U0110

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication