U010A
Lost Communication With Exhaust Gas Recirculation Control Module A
U010A is set when a stand-alone control module for exhaust gas recirculation A stops communicating. J2012 reserves this slot for engines whose EGR valve or EGR system is run by its own electronics on the bus rather than as a plain output of the engine controller; module B (U010B) would be a second such unit. No manufacturer documents U010A publicly, and the NHTSA bulletin index holds no entry for it. Because EGR lowers combustion temperature and NOx, CARB requires it to be monitored, so a lost EGR controller counts as emission-relevant. The nearest documented case is GM's boost control module (U010C), a smart actuator on a sensor bus. Expect EGR shut off and possibly reduced power. U040B covers invalid data.
Possible causes
- EGR module A without power or ground high
- Heat-damaged wiring or connector near the exhaust side medium
- Open or shorted bus lines to module A medium
- EGR module A internally faulty low
Symptoms
- MIL on
- EGR deactivated, higher NOx
- Possible reduced power mode
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for U010A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.