Network
generic / SAE
U0106
Lost Communication with Glow Plug Control Module
A control module that expects to talk to the engine ECU has stopped receiving messages. Most commonly seen by the TCM, instrument cluster, or BCM after the ECU has been disconnected, fitted with a faulty replacement, or the CAN wiring has been damaged. Engine usually will not run while this fault is active in other modules.
SystemNetwork
Typegeneric / SAE
GroupU0
Range / number1 / 06
Possible causes
- Glow plug module unpowered high
- CAN wiring to glow plug module broken medium
- Gateway module routing CAN messages incorrectly low
Symptoms
- Multiple warning lights may illuminate
- Affected modules may go into limp mode or shut down
- Specific functions inoperative depending on module
- Diagnostic tools may show communication faults
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
- Estimated cost: 80–1200 €
- Estimated time: 1–4 h
- Component: glow plug control module
- Component: can bus wiring
- MIL / check engine light
- emissions-relevant
Sources
References
sae:J2012