U0105
Lost Communication With Fuel Injector Control Module
U0105 concerns a separate fuel injector control module that drives the injectors on command of the engine controller. GM's 2005 Duramax 6.6 L (LLY) received a status message from this injector driver via CAN (J1939) whose toggle bit must flip every 20 ms; if it stalls for three updates, 30 failures in 50 checks give a Type B code. On the 2019 Corvette LT5 the ECM watches frame $1EA from a dedicated injector module and, after 10 s without it, logs U0105 as Type A on the first trip. Losing this link usually means misfire, power reduction or a stall, since the ECM can no longer confirm injection. U0406 covers invalid data and U0306 a software mismatch with the same module.
Possible causes
- Injector module supply low or missing (fuse, relay, battery voltage) high
- Loose or corroded connector or damaged CAN lines to the module medium
- Injector module internally faulty (heat, power stage) medium
Symptoms
- MIL on
- Misfire, rough running or reduced power
- Engine stalls or will not start
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U0105
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.