OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0102

Lost Communication With Transfer Case Control Module

U0102 is logged when the transfer case control module, which shifts between two- and four-wheel drive and between high and low range, stops sending. GM's 2025 engine controllers expect frame $035 and fail it when gaps exceed 425 ms within a 5 s window; the code is Type C, emissions-neutral and without MIL. The earlier two-mode hybrid trucks (2012 table) used Type B with 500 ms detection between 10 and 18 V. Ford's 2023 diesel controllers allow 5 s before flagging the TCCM. Bulletin 08-07-30-021H lists U0102 among GMLAN codes caused by shared bus faults. The driver mostly sees a 4WD warning and a transfer case left in its last range; engine and gearbox keep running. U0403 covers implausible data from the same module.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number1 / 02

Possible causes

  • Transfer case module without power or ground high
  • Water or corrosion in the module connector (often mounted low on the frame) medium
  • Damaged CAN lines to the transfer case module medium
  • Transfer case module internally faulty low

Symptoms

  • 4WD or AWD warning, range selection ignored
  • Transfer case stays in its last mode
  • Usually no MIL

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U0102

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication