OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0101

Lost Communication With TCM

U0101 means the transmission controller has dropped off the bus as seen by another node, mostly the engine controller. GM's 2019 truck ECMs watch eight TCM frames, most of them at 500 ms intervals, and set the code as Type A after battery and run voltage have exceeded 11 V for 3 s, provided U0073 is not active; GM's electronic range selector logs it as Type B after 1 s, the hybrid processor in the same table after 5 s. Ford's 2023 diesel summary flags the code when the TCM's master frame has been absent beyond 1 s, while the 2012 summary checks it only where the TCM is a separate unit. U0402 covers implausible TCM data, U0302 a software mismatch. Typical effects: dead gear display, fixed gear, MIL.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number1 / 01

Possible causes

  • TCM without power or ground (fuse, relay, connector) high
  • Spread or corroded terminals at the transmission harness connector medium
  • Chafed or open CAN lines to the TCM medium
  • TCM internally faulty, overheated or not programmed low

Symptoms

  • MIL on, transmission warning in the cluster
  • Gear indicator blank or flashing
  • Transmission locked in one gear
  • Scan tool cannot reach the TCM

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U0101

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication