U009E
Vehicle Communication Bus J Performance
U009E flags unreliable traffic on Vehicle Communication Bus J without a total loss. No manufacturer publishes a use of U009E. Interference is a likely source. Texas Instruments names fluorescent lamps, switching power supplies and motor drives as typical emitters of common-mode noise that couples onto bus lines, and explains that a receiver without good rejection may take it for data. A twisted pair and differential signalling keep this in check, so opened twists or retrofitted electronics near the harness are suspects. NXP adds that tolerated wiring faults also worsen electromagnetic behaviour. Where messages go unacknowledged, Wikipedia notes that nodes often resend them repeatedly, which can drive them into the error-passive state.
Possible causes
- Interference from nearby loads or retrofitted electronics high
- Bus wires untwisted at a repair medium
- Loose contact in a Bus J connector medium
Symptoms
- Short dropouts on Bus J, often with certain loads switched on
- Warnings that appear briefly and clear
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U009E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.