U0099
Vehicle Communication Bus H (-) High
U0099 describes a (-) wire on Vehicle Communication Bus H held at too high a voltage, most often through contact with battery power; on a CAN that wire is CAN-Low. Nothing public from a manufacturer covers U0099. NXP's data sheet for the fault-tolerant low-speed TJA1055 separates two cases: CAN-Low at battery voltage is recognised once the line stays above a comparator threshold for a set time, after which the chip turns off its CANL driver and listens over CANH alone; CAN-Low at the 5 V supply is tolerated without leaving differential mode. Recovery happens automatically after a run of recessive bits. On a high-speed CAN, by contrast, onsemi found that CAN-Low at 12 V blocks all transmission, so U007A for bus off may follow.
Possible causes
- (-) wire shorted to a battery feed high
- Corrosion or water in a connector between (-) and a supply pin medium
- Faulty transceiver driving the (-) line high low
Symptoms
- On high-speed CAN: Bus H goes silent
- On fault-tolerant CAN: degraded but working communication
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U0099
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.