U0098
Vehicle Communication Bus H (-) Low
U0098 is stored once the Bus H (-) wire, CAN-Low on a CAN, sits too low, normally from a short to ground. No manufacturer has made a use of U0098 public. With fault-tolerant low-speed CAN the short unfolds in stages: the receive pin of NXP's TJA1055 initially stays dominant without pause; once a time-out has passed, the chip disables its CANL driver and goes on receiving single-wire over CANH. Once the short is removed, normal levels return and the chip goes back to differential mode. Communication thus survives, but with less noise margin. A high-speed CAN also keeps running in this state, as onsemi measured, though with distorted levels. A resistance check of that wire against chassis, battery disconnected, confirms it.
Possible causes
- (-) wire chafed to ground high
- Harness pinched by a fastener or panel medium
- Faulty transceiver pulling the (-) line to ground low
Symptoms
- Usually no noticeable symptom
- Occasional errors on Bus H in electrically noisy conditions
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U0098
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.