U0096
Vehicle Communication Bus H (+) High
U0096 is set once excessive voltage appears on the Bus H (+) wire, as from a short to battery or to the module supply; on a CAN this is CAN-High. U0096 is not documented by any manufacturer in public. On a high-speed CAN such a short often leaves traffic running; NXP lists CAN-High to battery and to the 5 V supply among hidden failures. A fault-tolerant low-speed CAN reacts in steps. NXP's TJA1055 first switches to single-wire reception over CANH after a time-out and, if the line stays high, moves on to CANL and shuts off its CANH driver; the delays keep radio interference from triggering it. When the short is gone, the chip returns to normal by itself. Look for chafing against a supply wire or water in a connector.
Possible causes
- (+) wire touching a supply wire high
- Water in a connector bridging the (+) pin to a supply pin medium
- Faulty transceiver driving the (+) line high low
Symptoms
- Often no symptom, code found during a scan
- Sporadic dropouts on Bus H
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U0096
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.