U0095
Vehicle Communication Bus H (+) Low
U0095 indicates that the (+) wire of Vehicle Communication Bus H is held too low, usually through a ground short (CAN-High on a CAN). No public manufacturer document uses U0095. The effect depends heavily on the bus type. On a high-speed CAN, onsemi found that no frame can be sent with CAN-High grounded; the stuck node kept retrying in short bursts, its transmit line active only about 2 % of the time, and the supply current fell to about 50 mA. Repeated failures end in bus off, which would add U007A. NXP's fault-tolerant TJA1055, by contrast, copes with a grounded CANH without even leaving differential reception. The same code can therefore mean a dead network on one car and an unnoticed defect on another.
Possible causes
- (+) wire chafed against the body high
- Harness pinched during a repair or installation medium
- Faulty transceiver holding the (+) line low low
Symptoms
- On high-speed CAN: all Bus H modules fail together
- On fault-tolerant CAN: little or no noticeable effect
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U0095
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.