U0091
Vehicle Communication Bus G (-) Shorted to Bus G (+)
U0091 closes the Bus G block: the (-) and (+) wires of Vehicle Communication Bus G are joined, on a CAN CAN-Low to CAN-High. No manufacturer has published a use of U0091. With both wires bridged no voltage difference can form, so a high-speed CAN carries no frames at all. Transceiver self-diagnosis is of little help here; NXP notes that its TJA1043 reports shorts to ground and supply but not a short between the two bus wires, so the module concludes the fault from the silence. Measuring is quick: Nissan gives about 60 ohms between the wires as normal and lists zero ohms for a short between them. To find the spot, unplug modules and harness sections one at a time until the reading returns to normal.
Possible causes
- Bus wires crushed together, e.g. under a seat rail or panel high
- Corroded or wet splice bridging both wires medium
- Internal short in one module's transceiver low
Symptoms
- Complete loss of the functions served by Bus G
- Scan tool cannot reach any module on Bus G
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U0091
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.