U0090
Vehicle Communication Bus G (-) High
U0090 is logged when Bus G's (-) wire is pulled up, typically by a short to a supply feed; in CAN terms this is the CAN-Low line. U0090 is not described in any public manufacturer source. Unlike a grounded CAN-Low, this fault normally stops the bus: onsemi found transmission impossible with CAN-Low at 12 V, and NXP rates it as a short under which communication fails. The search is easier once you know which feed is involved. Nissan's CAN diagnostic chart measures each bus wire to ground both with the key off and with it on, and keeps separate entries for shorts to battery and to an ignition feed. A fault that is present only with the ignition on points to a switched circuit, one that persists with the key off to a permanent battery feed.
Possible causes
- (-) wire touching a switched ignition feed in the harness medium
- (-) wire shorted to a permanent battery feed high
- Retrofitted equipment spliced into the bus wires low
Symptoms
- All modules on Bus G stop responding at once
- Warning lamps and lost-communication codes in several systems
- Fault may come and go with the ignition switch position
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U0090
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.