OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U008F

Vehicle Communication Bus G (-) Low

U008F is the low-voltage fault on the (-) wire of Vehicle Communication Bus G, which on a CAN means CAN-Low touching ground. No public manufacturer document uses U008F. On a high-speed CAN this is one of the faults that let messages through: onsemi measured working transmission with distorted levels, and the node drew about 72 instead of 65 mA because a terminating resistor now drains to ground. NXP lists CAN-Low to ground among the shorts its TJA1043 reports although traffic continues, and warns that such tolerated faults raise current draw and spoil electromagnetic compatibility. A car can therefore run normally with U008F stored. With the battery disconnected, a (-) wire showing near zero ohms to chassis confirms it.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number– / 8F

Possible causes

  • (-) wire chafed through to the body or a bracket high
  • Moisture in a connector bridging the (-) pin to a ground pin medium
  • Damaged transceiver in one module pulling the line down low

Symptoms

  • Often no noticeable effect, code found during a scan
  • Sporadic dropouts on Bus G

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U008F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication