OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U008E

Vehicle Communication Bus G (-) Open

With U008E the (-) wire of Vehicle Communication Bus G is open, CAN-Low where Bus G is a CAN. U008E is not documented publicly by any maker. Seen with an oscilloscope, CAN-Low beyond the break no longer drops from about 2.5 V to the 1.5 V that Texas Instruments gives for a dominant bit, so receivers there get only the CAN-High half of the signal and less margin against noise. Termination suffers as well: TI recommends that the 120-ohm resistors sit at the line ends and not in a node, because a disconnected node takes its terminator with it, and a broken CAN-Low can cut one of them off in the same way. Transceivers do not flag the open line themselves, as NXP points out. Checking resistance between the wires from both sides of the vehicle helps locate the gap.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number– / 8E

Possible causes

  • (-) wire of Bus G broken at a flex point high
  • Bus G connector not fully latched or a terminal backed out medium
  • Corroded splice interrupting the (-) wire low

Symptoms

  • Modules beyond the break respond only sometimes
  • Code comes and goes with temperature or road shocks

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U008E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication