OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U008C

Vehicle Communication Bus G (+) Low

U008C indicates a (+) wire on Vehicle Communication Bus G pulled too low, usually grounded. No manufacturer documents U008C publicly. On a high-speed CAN the (+) wire is CAN-High, which Texas Instruments describes as rising from about 2.5 V to 3.5 V for every dominant bit while CAN-Low drops to 1.5 V, giving the 2 V difference receivers decode. A grounded CAN-High cannot rise, so no node can assert a dominant bit; onsemi saw transmission fail outright in this state. Each failed frame raises the sender's error counter, so the same module may also log U0079 once it goes bus off. The whole network falls silent and other networks log the missing modules. With the battery disconnected, CAN-High showing only a few ohms to chassis confirms the short.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number– / 8C

Possible causes

  • (+) wire of Bus G chafed against body metal high
  • Harness pinched by a screw, panel or seat medium
  • Defective transceiver holding CAN-High to ground low

Symptoms

  • All modules on Bus G drop out together
  • Many warnings and lost-communication codes at once

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U008C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication