U008B
Vehicle Communication Bus G (+) Open
On Vehicle Communication Bus G, U008B flags an open (+) conductor, which on a CAN means CAN-High. No manufacturer documents U008B publicly. A useful clue comes from the termination: Texas Instruments describes a high-speed CAN line ending in a 120-ohm resistor at each end, which a meter across CAN-High and CAN-Low sees as about 60 ohms. With CAN-High broken, only the resistor on the measuring side remains in the loop and the reading rises to roughly 120 ohms; on the other side of the break it is the same, which helps locate the gap. Meanwhile the far nodes miss part of the signal and fall silent or drop frames, and as NXP notes, transceivers do not report open lines themselves. Check the (+) wire through every connector of Bus G.
Possible causes
- (+) wire of Bus G broken at a hinge, seat or door passage high
- Terminal of the (+) wire pushed out of its connector cavity medium
- Corroded splice in the (+) wire low
Symptoms
- Some modules on Bus G not reachable with a scan tool
- Intermittent faults that change with temperature or movement
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U008B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.