OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0086

Vehicle Communication Bus F (-) Low

U0086 says the (-) wire of Vehicle Communication Bus F sits too low, usually shorted to ground. On a FlexRay Bus F, as in the Audi A6/A7, that wire is bus minus (BM). At rest both FlexRay lines float near half the transceiver supply, and NXP specifies a near-zero difference between them in idle. A grounded BM leaves BP well above it, a permanent positive difference that receivers read as DATA_1 instead of idle, which disturbs wake-up and frame recognition across the cluster. On a CAN the comparable fault, CAN-Low to ground, is usually harmless for traffic and stays hidden unless a transceiver with bus diagnosis reports it, as NXP describes. No manufacturer documents U0086 publicly. Measure the (-) wire to chassis with the battery disconnected.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number– / 86

Possible causes

  • (-) wire of Bus F chafed against body metal high
  • Harness trapped under a seat rail or trim medium
  • Transceiver of one module pulling the (-) line to ground low

Symptoms

  • Modules on Bus F fail to wake or drop out
  • On CAN layouts often no noticeable symptom

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U0086

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication