U0084
Vehicle Communication Bus F (+) High
U0084 is set when the (+) wire of Vehicle Communication Bus F carries too much voltage, typically after contact with battery power. For a FlexRay Bus F, as in Audi's A6/A7, the wire is bus plus (BP); NXP rates the bus pins of its TJA1081B to withstand shorts to 14, 24 and 48 V and caps the output current at about 72 mA, so the hardware usually survives while signal levels are wrong. If Bus F is a CAN, CAN-High at supply voltage is one of the faults that may leave traffic running: onsemi still saw frames pass, and NXP counts it among hidden failures that only a diagnosing transceiver reports. Volvo lists shorts of CAN-High to power behind its truck code U008088. No manufacturer documents U0084 itself. Look for wiring touching a feed or a wet connector.
Possible causes
- (+) wire of Bus F touching a battery or ignition feed high
- Water in a connector bridging the bus to a supply pin medium
- Faulty aftermarket wiring tapped into the bus low
Symptoms
- Often no symptom, code found during a scan
- Sporadic dropouts of functions on Bus F
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U0084
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.