OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0082

Vehicle Communication Bus F (+) Open

U0082 reports an interrupted (+) wire on Vehicle Communication Bus F. Where Bus F is FlexRay, as Audi's A6/A7 bulletin suggests, this is bus plus (BP); in a CAN it would be CAN-High. FlexRay signals by the voltage difference between BP and BM, and NXP's TJA1081B only accepts activity once that difference exceeds a threshold of about 150 to 300 mV. Nodes beyond a broken BP therefore receive a reduced or missing signal, while the sender keeps seeing its own output intact on its side of the break, so its bus error flag stays quiet. The fault shows as partners that stop answering. No manufacturer documents U0082 publicly; Volvo and Mack trucks fold line breaks on their datalink 7 CAN into U008088. Check BP continuity connector by connector.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number– / 82

Possible causes

  • (+) wire of Bus F broken at a flex point or after chafing high
  • Terminal of the (+) wire pushed back in a connector medium
  • Inline connector of Bus F not fully latched medium

Symptoms

  • Modules on the far side of the break no longer respond
  • Warnings that come and go with vehicle movement

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U0082

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication