U007B
Control Module Communication Bus I Off
U007B is tied to no published manufacturer use; a Bus I only exists on vehicles split into many separate networks. The cause need not sit in the wiring at all. Onsemi describes a node whose transmit pin cannot produce a dominant level: every start-of-frame attempt fails and raises the error counter by eight, after 17 attempts it is error passive and shortly afterwards bus off, although the remaining bus may keep running normally. A damaged transceiver, a supply dip at the module or a cracked solder joint can therefore produce U007B in a single module only. If the code returns after clearing, check that module's power and ground under load and swap it against a known good unit before opening the harness.
Possible causes
- Transceiver in the reporting module unable to drive the bus medium
- Weak supply or ground at the reporting module medium
- Short or open in the Bus I wiring low
Symptoms
- Only the reporting module's functions drop out
- Code returns soon after clearing
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U007B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.