U007A
Control Module Communication Bus H Off
Bus H appears in no public manufacturer document for U007A; the code merely says that one module's CAN controller has switched to bus off on the network its maker labels H. A sensible check order follows from the physics. A high-speed CAN carries a 120 ohm resistor at each end, so with the battery disconnected the two wires should show roughly 60 ohms between them; about 120 ohms points to a missing terminator, near zero to the wires touching. With ignition on, a dominant bit pulls CAN-High toward 3.5 V and CAN-Low toward 1.5 V. As onsemi shows, a bus that is held recessive pushes a sender into bus off within a few dozen bit times, so shorts and transceiver damage come before software in the search.
Possible causes
- Bus H wires shorted together medium
- Terminating resistor open or a terminating module disconnected medium
- Transceiver damaged, e.g. by overvoltage low
Symptoms
- Functions on Bus H fail or work only intermittently
- Warning messages from several systems
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U007A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.