OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0073

Control Module Communication Bus A Off

U0073 is logged by a module whose own CAN controller has withdrawn from Bus A. Each failed transmission adds eight to its transmit error counter; above 255 the chip goes bus off and may rejoin only after 128 runs of 11 recessive bits (onsemi). GM's 2019 tables flag more than five bus-off events, about 0.06 s, inside a 0.81 s window as Type A with MIL on the first trip, and the ECM suspends lost-communication tests such as U0101 while it is active. Around 2006 GM still reported this state as U0001. A Ford TCM turns the MIL on at once because engine speed is missing. Bulletins trace U0073 to a loose ground (Trax, G103), backed-out terminals in the 6L80 transmission connector and harness rubbing on a cylinder head (Silverado LV3). Expect several warnings, possibly a gearbox held in one gear.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number– / 73

Possible causes

  • Bus A wires chafed through or shorted to ground in the harness high
  • Loose or corroded ground point of a module on Bus A medium
  • Backed-out or loose terminals, e.g. in the transmission connector medium
  • Open or shorted terminating resistor low

Symptoms

  • MIL and several cluster warnings at the same time
  • Transmission stuck in one gear or shifting harshly
  • Gauges fluctuate or drop out briefly
  • Lost-communication codes such as U0100 or U0101 in other modules

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U0073

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication