U0068
Vehicle Communication Bus E (+) High
U0068 flags the (+) wire of Vehicle Communication Bus E at an excessive voltage, from battery or a 5 V rail. If Bus E is a high-speed CAN, the line in question is CAN-High, and traffic continues: onsemi saw frames pass with altered dominant levels, NXP files the case under hidden failures. Detecting it therefore depends on the module. NXP's TJA1041 note explains that a diagnosing transceiver must itself send at least four sufficiently long dominant phases before its failure flag is valid, and recommends reading the flag once a frame has finished, because arbitration with other senders can distort the measurement. That is why only some modules on Bus E, or none, may store the code. No manufacturer documents U0068 publicly. A meter on CAN-High showing roughly supply voltage to ground proves it.
Possible causes
- (+) wire of Bus E chafed against a battery or 5 V feed high
- Moisture in a connector bridging the bus wire to supply medium
- Aftermarket device connected to the bus wire low
Symptoms
- Usually no symptom, code found by chance
- Code stored in only one module on Bus E
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U0068
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.