U0067
Vehicle Communication Bus E (+) Low
U0067 tells of the (+) conductor of Vehicle Communication Bus E being grounded. For a Bus E built as a high-speed CAN that is CAN-High, which a dominant bit needs to raise by about a volt; grounded, it cannot. onsemi describes the resulting cycle: the controller attempts a start-of-frame, fails, flags errors, becomes error passive and finally bus-off, then must wait for 128 groups of eleven recessive bits before it may try again, so its transmit line is active only about 2 % of the time. Every Bus E node goes silent, and modules on other networks log them as missing. NXP's fault-tolerant TJA1055 low-speed chip, by contrast, carries on despite the same short. No manufacturer documents U0067 publicly. CAN-High at a few ohms to ground with the battery off confirms it.
Possible causes
- (+) wire of Bus E chafed through to body ground high
- Harness trapped behind the dashboard or a trim panel medium
- Shorted transceiver in a module on Bus E low
Symptoms
- All functions on Bus E fail together (high-speed type)
- Missing-message codes in modules on other networks
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U0067
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.