U0066
Vehicle Communication Bus E (+) Open
U0066 indicates a break in the (+) wire of Vehicle Communication Bus E. Where Bus E is a two-wire CAN, like the infotainment CAN Audi and Volkswagen monitor under that slot, the (+) wire is CAN-High. The physical layer decides how visible the fault is. With fault-tolerant low-speed hardware, NXP's TJA1055 rides through a CAN-High interruption with drivers, termination and differential receiver left as they were, and only counts edges: once CAN-High and CAN-Low differ by four pulses, its error output goes low. A high-speed transceiver offers no such check, so modules notice only that partners beyond the break fall silent. No manufacturer documents U0066 publicly; Audi's A3 case of a badly seated contact carrier in a multi-pin connector shows how such interruptions arise.
Possible causes
- (+) wire of Bus E broken in the harness high
- Contact carrier or terminal not seated in a multi-pin connector medium
- Connector left unplugged after a repair low
Symptoms
- Modules beyond the break, often infotainment units, unreachable
- Lost-communication codes for individual modules
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U0066
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.