U0063
Vehicle Communication Bus D (-) Shorted to Bus D (+)
U0063 covers a short circuit between both conductors of Vehicle Communication Bus D. On a CAN-type Bus D the receivers then measure no voltage difference, read every bit as recessive and cannot see any frame start; onsemi lists this short with those that block transmission completely. It is also one of the two fault classes, along with wire breaks, that NXP's TJA1041 bus diagnosis explicitly does not detect, so modules infer it from error counters and silent partners. A useful check uses the termination: with the battery disconnected, a healthy high-speed pair reads about 60 ohms between the wires, while this fault gives close to zero. If the short sits inside a module, unplugging modules one at a time brings the reading back. No manufacturer documents U0063 publicly.
Possible causes
- Harness crushed so that both Bus D wires touch high
- Water in a splice or connector bridging the pair medium
- Damaged transceiver shorting its two bus pins low
Symptoms
- All modules on Bus D unreachable at once
- Several warning lamps or fallback modes
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U0063
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.