U0062
Vehicle Communication Bus D (-) High
U0062 means the (-) conductor of Vehicle Communication Bus D is forced high, usually by contact with battery plus. Built as high-speed CAN, Bus D carries this fault on CAN-Low, which can then no longer be pulled down any more; onsemi and NXP both list this short among those under which no frame gets through, so every Bus D member eventually ends up bus-off and other networks log its absence. Diagnosing transceivers such as NXP's TJA1041 recognise the short when its resistance is between 0 and 50 ohms. Texas Instruments adds a hardware angle: termination resistors should be rated for such a short, since a bus wire shorted to a 24 V line loads them with the transceiver's short-circuit current times that voltage, enough to destroy a quarter-watt part. No manufacturer documents U0062 publicly. CAN-Low near battery voltage confirms it.
Possible causes
- (-) wire of Bus D chafed against a battery or ignition feed high
- Water in a connector linking the (-) wire to a supply pin medium
- Termination or transceiver damaged by a lasting short to supply low
Symptoms
- All functions on Bus D fail together
- Lost-communication codes in modules on other networks
- Warning lamps or fallback modes depending on the modules involved
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U0062
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.