U0061
Vehicle Communication Bus D (-) Low
U0061 reports the (-) wire of Vehicle Communication Bus D held at ground potential; a Bus D designed as high-speed CAN has CAN-Low in that role, which normally swings only between about 2.5 V and 1.5 V. Texas Instruments gives the tolerated common-mode range of ISO 11898 receivers as anything between -2 V and +7 V, so a grounded CAN-Low still lies inside the window and the receivers keep decoding; onsemi confirms that frames continue with distorted levels. What changes is current: the upper output stage of the sending node now feeds the 60-ohm load directly into ground, raising its draw to roughly 72 mA in onsemi's test. The code typically sits in one module with diagnostic transceiver while Bus D keeps working. No manufacturer documents U0061 publicly. With the battery off, CAN-Low reads near zero ohms to ground.
Possible causes
- (-) wire of Bus D chafed against a ground point or body edge high
- Water in a connector linking CAN-Low to a ground pin medium
- Faulty transceiver pulling the (-) line down low
Symptoms
- Often no symptom, code stored in a single module
- Occasional interference-related message errors
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U0061
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.