OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0053

Vehicle Communication Bus C (-) High

U0053 reports too much voltage on the (-) conductor of Vehicle Communication Bus C, meaning CAN-Low if Bus C is built as a high-speed CAN, and NXP's TJA1041 application note states that a short of CAN-Low either to battery or to the 5 V transceiver supply makes communication impossible, while onsemi's measurements show the transmitting node stuck in endless failed attempts. All Bus C members go quiet together. A fault-tolerant low-speed bus separates the two cases: the TJA1055 data sheet treats CAN-Low at 5 V as a failure it simply tolerates, but at battery voltage it switches off its CAN-Low driver after a delay and receives over CAN-High alone. No manufacturer documents U0053 publicly. With the ignition on, CAN-Low near 5 V or battery voltage against ground confirms the fault.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number– / 53

Possible causes

  • (-) wire of Bus C touching a battery or 5 V feed high
  • Moisture in a connector bridging the (-) wire to a supply pin medium
  • Damaged transceiver holding CAN-Low high low

Symptoms

  • All functions on Bus C drop out at once (high-speed type)
  • Lost-communication codes in modules on other networks
  • Warning lamps or fallback modes depending on the affected modules

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U0053

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication