U0052
Vehicle Communication Bus C (-) Low
U0052 signals a ground short on the (-) line of Vehicle Communication Bus C; where Bus C follows the high-speed CAN layout, the affected line is CAN-Low, and NXP's application note for the TJA1041 lists this short among the hidden bus failures: nodes keep communicating, so a controller only learns of it from a transceiver with bus diagnosis. Such a transceiver needs at least four dominant phases of 4 µs or more on the wire before its failure flag is valid, and it reliably catches shorts between 0 and 50 ohms. The price of the fault is a smaller noise margin; with high bus capacitance dominant periods can stretch until bit timing is violated. The vehicle therefore usually drives normally and the code appears in a single module. No manufacturer documents U0052 publicly. Battery off, CAN-Low shows practically zero ohms to chassis.
Possible causes
- (-) wire of Bus C chafed against body metal high
- Harness trapped under a trim panel or seat rail medium
- Transceiver in one module pulling CAN-Low to ground low
Symptoms
- Often no noticeable symptom, code found during a scan
- Occasional brief warning from a module on Bus C
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U0052
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.