OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0051

Vehicle Communication Bus C (-) Open

U0051 stands for a severed (-) conductor on Vehicle Communication Bus C, CAN-Low where Bus C is a CAN. Deutz, which places Bus C on the fourth CAN channel of the EMR L1 engine control unit, does not use this code and books CAN 4 faults only as open circuit (U0048) or short circuit (U0054). A high-speed transceiver cannot see the interruption itself, as NXP points out, so the module only notices that partners on the far side stop acknowledging or sending. NXP's fault-tolerant low-speed TJA1055 instead compares the edge counts on both wires and flags a difference of four pulses; since that works only when the break lies between sender and receiver, its error output tends to toggle. No car maker documents U0051 publicly. Check CAN-Low continuity connector by connector.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number– / 51

Possible causes

  • (-) wire of Bus C broken at a flex point or splice high
  • Terminal pushed back or spread in a Bus C connector medium
  • Corroded splice interrupting the (-) line low

Symptoms

  • Modules beyond the break no longer respond
  • Code comes and goes while other modules keep working

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U0051

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication