OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0048

Vehicle Communication Bus C (+) Open

U0048 stands for an open (+) wire on Vehicle Communication Bus C, CAN-High where Bus C is a CAN. Deutz places the code on CAN 4 of its EMR L1 engine controller, listed for main and secondary ECU as an open circuit on that channel, just as U0039 covers CAN 3. Electrically, an interrupted CAN-High wire splits a high-speed CAN into islands that keep working internally; NXP points out that transceiver diagnosis cannot report such a break, so the controller relies on missing messages. A fault-tolerant low-speed transceiver such as NXP's TJA1055 rides through the same break with its drivers left active. Expect lost-communication entries for nodes located past the interruption. No car maker documents U0048 publicly. Check connector seating, crimp terminals and harness flex points first.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number– / 48

Possible causes

  • (+) wire of Bus C broken at a flex point or splice high
  • Loose crimp or backed-out terminal medium
  • Connector not fully seated medium

Symptoms

  • Modules on the far side of the break unreachable
  • Lost-communication codes in several modules

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U0048

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication